Assembly Instructions

3
Figure 1
STEP 1
AB20062_G5
R
U
I
R
T
T
U
K
D
E
S
STEP 2
Construct Short Foot and Head assembly:
Short Head Assembly:
Insert Allen Head Bolts (S) and (T) and Connector
Nuts (U) into holes in Foot Post Left (I) and
Stationary Post Left (E) as shown to ll in unused
Holes. Tighten Bolts with Allen Wrench (BB).
Align Stationary Post Left (E) with Short Head
Assembly (D). Insert Allen Bolts (R) and Snug Bolts
with Allen Wrench.
Align Foot Post Left (I) with Short Head Assembly
(D). Insert Allen Bolts (R) and Snug Bolts with Allen
Wrench.
Align Cleat (K) with 2 holes in the lower front of
Short Head Assembly (D). Insert Allen Bolts (R) and
Snug Bolts.
Tighten all Nuts and Bolts securely.
See gure 1.
Repeat the above procedure with Short Foot
Assembly (C) Stationary Post Right (F) and Foot
Post Right (J).
Figure 2
AB20072_G6
G
V
AA
E
P
A
Stationary Side Assembly to Short Head Assembly:
Place Joint Connector Nuts (V) into holes in the
bottom of top rail Stationary Side Assembly (A) and
bottom of bottom rail of Stationary Side Assembly
(A). Align Stationary Post Left (E) with Stationary
Side Assembly (A). Insert Allen Head Bolts (P) into
lower 2 holes of Stationary Post Left (E) and Rotate
Joint Connectors Nuts to align threads with bolts
and snug with Allen wrench.
Insert Dowel Pin (AA) into center hole of the Top
Back Rail Assembly (G). Place Joint Connector Nut
(V) into hole in the back of Back Rail Assembly (G).
Place groove in bottom of Back Rail Assembly (G)
over tenon in top of Stationary Side Assembly (A).
Insert Allen Head Bolt (P) into Stationary Post Left
(E) and Rotate Joint Connectors Nut to align threads
with bolts and snug with Allen wrench.
Tighten all Nuts and Bolts securely.
See gure 2.