Assembly Instructions

5
Figure 5
STEP 5
Add Mattress Spring to crib.
There are 2 positions for the Spring (O) shown as
(1) and (2). The position must be the same as for all
the brackets attached to the crib.
Note: Pouches containing warnings and instructions
face up on top surface of Spring.
Position tabs on Spring at approximately a 45
degree angle. The Spring (O) is lowered into the
crib. Take care not to scratch the wood with the
metal Spring. Align the Spring Brackets with the
holes in the crib at the desired height. Insert
Allen Bolt (T) into hole in spring brackets from inside
of crib then through correct height hole in the crib
together with Connector Nut (U). Insert
Connector Nuts (U) and Allen Head bolts (T) into
unused Holes.
Tighten all bolts securely with Allen Wrenches.
To Adjust height of Spring (O) remove Nuts and
Bolts. Then relocate Spring (O) to new height
adjustment level and install Nuts and Bolts as
described in previous paragraph.
See gure 5.
AB20062_G9
2
1
O
T
U
T
U
AB20062_G10
P
V
I
B
P
J
Figure 6
STEP 6
Construct Long Foot Assembly to crib:
Align Long Foot Assembly (B) between Foot Posts
(I) and (J). Insert Joint Connector Nuts (V) into Long
Foot Assembly rails. Insert Allen Bolts (P) through
Foot Posts. Rotate Joint Connectors Nuts to align
threads with Bolts and snug with Allen wrench .
Insert additional Allen Bolts (P) into Bottom of Base
Front Rail Assembly (H) and into Long Foot
Assembly (B).
Tighten all Nuts and Bolts securely.
See gure 6