User guide

Operating System Setup - 9
Concise User’s Guide
English
Operating System Setup
If you are installing new system software, or are re-configuring your computer for a different system, make sure you
configure the appropriate OS setting in the BIOS before installing a new operating system.
1. Start-up the computer and press <F2> to enter the BIOS.
2. Go to the Advanced menu, select "Installed O/S" and make sure the appropriate operating system is selected.
3. Go to the Exit menu and select "Exit Saving Changes" (or press F10) and press Enter to exit the BIOS and
reboot the computer.
Figure 2 - BIOS (Operating System Selection)
Main Advanced Security Boot Exit
F1 Help  Select Item -/+ Change Values F9 Setup Defaults
Esc Exit  Select Menu Enter Select Sub-Menu F10 Save and Exit
Item Specific Help
Advanced
Select options for
Advanced Chipset
features.
Phoenix SecureCore(tm) Setup Utility
Advanced Chipset Control
Installed O/S: [Vista]
SATA Mode Selection: [AHCI]
DFOROM(Robson) Support: [Disabled]
Reset Configuration Data: [No]
Boot-time Diagnostic Screen: [Disabled]
Legacy OS Boot: [Enabled]
Power On Boot Beep [Disabled]
Battery Low Alarm Beep: [Disabled]
FAN Control: [Automatic]
Only available if Windows Vista
is selected as the O/S.

SATA Mode Selection & Intel Turbo
Memory Module
If you select the Vista O/S then the SATA
Mode Selection menu will become avail-
able.
If you have included an Intel Turbo Memory
module in your purchase configuration you
will need to enable
"DFOROM (Robson)
Support
" and then install the driver (see
“Intel Turbo Memory Module” on
page 35).
M730T vista Concise UG.book Page 9 Thursday, September 25, 2008 1:14 PM