User Manual

Upgrading The Computer

6 - 6 Upgrading the Hard Disk Drive(s)

Removing the Hard Disk in the Secondary HDD Bay (Model B Computers Only)

If you want to configure your hard disks in a RAID configuration then install iden-

tical drives in the primary (see page 6 - 4) and secondary hard disk bays as per the

instructions here. Follow the instructions in “Setting Up SATA RAID or AHCI

Modes” on page 7 - 60 for configuration details. Note a RAID configuration is only

supported by Model B computers.

1. Turn off the computer, and turn it over and remove the battery.

2. Locate the component bay cover and remove screws

- .

3. Carefully remove the cover .



RAID Hard Disks

All hard disks in a RAID

should be identical (the

same size and brand) in

order to prevent unex-

pected system behavior.

Figure 6 - 4

Component Bay

Cover Screws

1 11

Model B

1011