Full Product Manual

5
Step 4. Removing the Tube or Plug
• Make sure to completely eliminate all pressure before removing
the tube from the Quick Connector Union fitting.
• Turn off the incoming feed water and open the faucet.
• When removing the tube or plugs, push and hold the collet clip
in against the fitting as you pull the tube or plug out. This
releases the tube or plug.
• Fittings and tubes can be reused. Be sure to check for possible
scratches on the tube when reusing.
8. PRIMARY COMPONENTS DIAGRAM
9. ADJUSTING THERMOSTAT
 The water temperature can be adjusted by turning the screw on the cold
water thermostat as located in the diagram above. Use a small straight blade screw
driver. Turn clockwise to make colder. Turn counterclockwise to make warmer. Do
not force the turning pressure to the thermostat with the screwdriver, as excessive
force can damage the thermostat. Caution: Adjusting the thermostat should be
performed by a professional. Adjusting the thermostat too cold may cause the Chiller to freeze up.
10. SPECIFICATIONS