User's Manual

PRODUCT SPECIFICATIONS
• Bluetooth version : 2.1+EDR
• Operating distance : 33FT
• Battery :1200mAh
• Output Power :1.8 Watt x2
• Charging :Approx 1-2 hours
• Playback :Approx 4-5 hours
PACKAGE CONTENTS
• Bluetooth Speaker
• Micro USB Charging Cable
• 3.5mm Auxiliary Cable
• User Manual
LED INDICATOR
Charging : Red LED on
Fully charged : Red LED off
Pairing mode : Blue LED flash quickly
Connected : Blue LED on
Playing : Blue LED flash slowly
SAFETY INFORMATION
Do not attempt to disassemble the divece .
Doing so ,May result in an electronic shock .
Do not use this device on an aircraft or in a hospital .
Do not expose this device to direct sunlight ,heat or open flame .
Device May became warm while charging .
CAUTION
Any changes or modification to this device ,not expressly approved
by the party responsible for compliance ,could void the user ‘s
authority to operate this device .
This device and it’s antenna(s) must not be co-located or operated
in conjunction with any other antenna or transmitter .
SPEAKER BUTTON FUNCTION
1.Phone answer :Press to answer call ,press again to end call .
2.Mode :Press to change modes from bluthooth to audio .
Connect an AUX cable from a mobile device or computer to this
speaker to play music ,if Bluetooth is unavailable .
3.Volume down : Press and hold to decrease volume .
Previous song : Short press for previous song .
4.Volume up : Press and hold to increase to volume .
Next song : Short press for next song .
5.Play / Pause :Press to pause currently playing song,press again
to resume play .
6.AUX IN :3.5mm audio input (line-in ).
7.DC 5V:Use the included Micro USB cable to connect the device
to a computer USB port /AC power adapter with USB to charge .
8.RESET:In case of speaker malfunction press the RESET button .
9.ON/OFF switch .
PAIRING THE DEVICE
1.Place speaker within 30ft Bluetooth enabled device .
2.Switch the power botton from OFF to ON ,a tone will play
indicating device is on .The blue LED will light up then flash
quickly to indicate pairing mode .
3.On you device’s bluetooth menu ,find and select “xxxxxx” .
(you May required to enter a password “0000”).
4.A tone May sound and the blue LED will stay on when pairing
is complete .
BASIC INSTRUCTIONS
To turn speaker on ,switch power button from OFF to ON.
The speaker will beep and a blue LED will flash quickly .
The blue LED will blink slowly when playing music .
The speaker will beep every 20 seconds when battery is low .
To turn speaker off ,switch power button from ON to OFF .
CHARGING DEVICE
Before using this speaker for the first time ,charging for 24 hours.
1.Plug the Micro end of the charging cable into the port on the
speaker. Plug USB end into a computer ‘s USB port or a
compatible AC wall adapter .
2.The red LED will turn on to indicate the device is charging .
3.Once fully charged ,the red LED will turn off and a blue LED
will turn on .
When battery is low ,approximately 2hours of charging time is
needed to fully recharge the battery .
AUX DC IN OFF ON
1
6 7 8 9
2 3 4 5