User's Manual

D2-713G User Manual | 18
4.1 Internet Settings (Please refer to section 2.1 for details) 4.2 Sound Settings In Sound settings, you may adjust the volume of media/notifications/alarms , choose the default notification ringtone, as well as mute all sounds. 4.3 Display Settings Display settings include: Brightness, Wallpaper, Sleep and Font Size Brightness Adjust the brightness of the screen by sliding left or right. Wallpaper Change the wallpaper on your home screen by selecting image from available galleries. Sleep Adjust idle time before the screen locks and the tablet enters standby mode. Font size Set system font size with four options: Small, Normal, Large, Huge.
D2-713G User Manual | 3
for typical body-worn operations with the back of the handset kept 0cm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a 1.5cm separation distance between the user's body and the back of the handset. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided. FCC WARNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. NOTE 2: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.
D2-713GUserManual.indd Spread 5 of 12 - Pages(20, 5)D2-713GUserManual.indd Spread 5 of 12 - Pages(20, 5) 6/13/2013 6:38:53 PM6/13/2013 6:38:53 PM