User's Manual
Table Of Contents
- 1._The_Summary_of_uSat_Flat_Portable_Ter
- 2._Technical_Specification
- OLE_LINK5
- OLE_LINK4
- 3._Packing_List
- 4._The_Description_of_uSat_Flat_Portable
- 4.1_Structure_Diagram
- 4.2_Device_Details
- 5._Operation_steps
- 5.1_APP_User_Manual
- 5.3_Collection_Steps
- OLE_LINK1
- 5.4_Matters_Needing_Attention
- 6._Simple_Fault_and_Maintenance
- 6.1_Troubleshooting
- 6.2_Maintenance
- 7._After-Sales_Service
China Starwin Science & Technology Co., Ltd.
Tel: +8629-88664381, E-mail:
sales@starwincom.com, http://www.starwincom.com
Copyright © 2019 China Starwin
OR OTHERWISE AND WHETHER BASED ON THIS AGREEMENT OR
OTHERWISE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
(b) TO THE EXTENT PERMITTED BY APPLICABLE LAW, IN NO EVENT SHALL
THE LIABILITY FOR DAMAGES HEREUNDER OF CHINA STARWIN OR ITS
EMPLOYEES OR AGENTS EXCEED THE PURCHASE PRICE PAID FOR THE
PRODUCT BY PURCHASER, NOR SHALL THE AGGREGATE LIABILITY FOR
DAMAGES TO ALL PARTIES REGARDING ANY PRODUCT EXCEED THE
PURCHASE PRICE PAID FOR THAT PRODUCT BY THAT PARTY (EXCEPT IN THE
CASE OF A BREACH OF A PARTY'S CONFIDENTIALITY OBLIGATIONS).
FCC ID: 2AUBBFL60P-E
FCC Statement
The device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Danger: FCC Radio Frequency Exposure Information
In order to comply with RF exposure requirements, antennas must be installed to ensure a
minimum separation distance of 11.0m (antenna main beam) and 0.26m ( out range of +/-10
degrees off-axis) and must not be co-located or operating in conjunction with any other
antenna or transmitter except in accordance with accepted multi-transmitter product
procedures.