User's Manual

China Starwin Science & Technology Co., Ltd.
Tel: [phone], E-mail:
[e-mail], http://www.starwincom.com
Copyright © 2019 China Starwin
7. The main interface is divided into two main functions.
Device information: The current parameter configuration of the device, the display of device
attitude, as well as the real time and maximum values of the signal quality obtained under
the current mode, as shown in Figure 5-5-14.
Search setting: Local oscillator selection list, satellite selection list, polarization selection list,
frequency input box (DVB mode), symbol rate input box (DVB mode), as shown in
Figure 5-5-12 MODEM mode, as shown in Figure 5-5-13 DVB mode, and location
parameters, after set up the satellite-searching parameters in this interface, click "SEND
TO THE DEVICE", then confirm the parameters are correct, click "OK", the parameters
can be sent to the device, and then according to the APP prompt, you can choose to
reconnect the device or cancel, as shown in Figures 5-5-16 to 5-5-18, if canceled, the
interface will return to Bluetooth device list interface as shown in Figure 5-5-9.
Figure 5-5-15 Figure 5-5-16 Figure 5-5-17
8. If you need to disconnect, click the three dots on the upper right corner and select
"Disconnect device", then click the “Ok”, as shown in Figure 5-5-19.
9. Adding satellite: Click on the three dots in the upper right corner, then click
“Management Center”, “Satellite management” in turn, APP has built in the frequently-
used satellite,
If there are target satellite, you just check the circle front the satellite, as shown in Figure
5-5-20.
If there are not the target satellite, click the "+" on the upper right corner to enter the
satellite add interface, as shown in Figure 5-5-19, enter the satellite name and satellite
longitude, click "SAVE" to complete the addition, then return to the previous step, check