Computer Hardware User Manual

Jack PC Hardware User Manual - Training Department

Revision C 0506

Welcome and congratulations on your purchase of the Jack PC!

This User Manual contains the information you will need in order to set up your Jack PC's

hardware.

For information concerning the Jack-PC's software aspects, please refer to the Software User

Manuals, that can be found at www.chippc.com

1 SAFETY NOTICES

This section contains important safety notices. Please read carefully as improper handling of the

product may result in serious personal injury and/or termination of warranty!

Caution: Never open the product’s enclosure and never attempt to replace or fix any internal

part! Any attempt to repair the product, install or replace components by an unauthorized person

could expose that person to risk electrical shock and will cause the product warranty to be void.

Only trained and qualified personnel should be allowed to install, replace, or service

this equipment. For any problem, please contact the nearest authorized service provider.

Caution: To prevent possible electrical shock when installing the product, do the following:

Make sure that the connected display is properly grounded through the mains plug.

Any peripheral device connect to the Jack-PC, must be connected to properly wired receptacles.

Caution: when using an external power supply (5VDC AC/DC adapter) use only Chip PC-

supplied, UL-listed direct plug in AC/DC adapter, (Chip PC part number: CPN1491 or CPN1503

or CPN1504). Using a different power supply might expose the user to various risks, damage the

device and will void the product's warranty!

Caution: When using USB devices that power from the Jack-PC's UBS ports, be aware that

heavy electrical loads on the USB ports can cause instable operation and excessive heat buildup;

therefore it is better to use the USB device's external power supply.

Caution: This product is designed for indoor use only!

Important Note: When preparing a new installation, note the following cautions:

• Do not drill next to electricity/telephone lines.

• Test for existence of power lines or enforcement beams prior to drilling the wall

cutout.

• Make sure to comply with any building standards that might exist in the

building that the Jack PC is designated to be installed.

Important Note: The product is to be installed in compliance with the requirements of

the Canadian electrical Code (CEC) and the National Electrical Code in USA.