User's Manual

This document is exclusive property of CHIPSEA and shall not be reproduced or copied or transformed to any other format
without prior permission of CHIPSEA
10/11 NO：CS-QR-YF-054A02
Gathering ICs bit by bit and forming vast sea.
A. Appendix A
A.1. Requirement of FCC KDB 996369 D03 for module certification:
1.1 List of applicable FCC rules:
The module complies with FCC Part 15.247
1.2 Summarize the specific operational use conditions:
The module has been certified for Fix, Mobile, Portable applications. This transmitter must not be co‐located
or operating in conjunction with any other antenna or transmitter.
1.3 Limited module procedures:
The module has not its own RF shielding, which belong to Limited module Standard requires:
Clear and specific instructions describing the conditions, limitations and procedures for third‐parties to use
and/or integrate the module into a host device (see Comprehensive integration instructions below).
Resolve: Supply example as follows:
Installation Notes:
1) CSM92F30 Module Power supply range is DC 1.8V~3.6V, when you use CSM92F30 Module design
product, the power supply cannot exceed this range.
2) When connect CSM92F30 Module to the host device, the host device must be power off.
3) Make sure the module pins correctly installed.
4) Make sure that the module does not allow users to replace or demolition.
1.4 Trace antenna designs:
Not applicable.
1.5 RF exposure considerations:
This modular complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This modular must be installed and operated with a minimum distance of 20 cm between the radiator and user
body.
Note: the host product manuals must include a statement in order to alert the users of FCC RF exposure
compliance.
1.6 Antennas:
Type Gain
Frequency Bands Modulation Mode
PCB 0.5dBi
2402-2480 MHz
GFSK
The antenna is permanently attached, can’t be replaced.
1.7 Label and compliance information
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio