User's Manual

This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
 Any changes or modifications not expressly approved by the party
responsible for compliance could void the authority to operate
equipment.
 This device and its antenna must not be co-located or operating in conjunct
ion with any other antenna or transmitter.
 End-users and installers must be provided with antenna installation
instructions and transmitter operating conditions for satisfying RF
exposure compliance.
 For product available in the USA/Canada market, only channel 1~11 can be
operated. Selection of other channels is not possible
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.