CSF089W USER MANUAL BAR FREEZER Keep this manual in a safe location and use it for reference. Read this manual carefully before commencing operation of this appliance, and comply with the Terms and Conditions. www.chiq.com.
PART NAMES AND LOCATIONS 1 Top cover 2 Display Block 3 Freezer Flap 4 Middle Drawer 5 Low Drawer 6 Adjustable feet As the manufacturer holds the authority to redesign or modify its products without notice: Any modifications or upgrades of our products will result in this freezer varying slightly from this manual but the functionality will remain the same to that as set out within this manual.
IMPORTANT SAFETY INSTRUCTIONS WARNING Follow these basic precautions to reduce the risk of fire, electrical shock hazards or injury when operating the freezer: It is critical use this appliance safely. Read all instructions before operating the freezer and do not attempt to repair or modify this unit in any way as it can cause harm or void the warranty.
R600a WARNINGS NOTE: This model uses R600a flammable refrigerant in its sealed system. The following must be observed for your safety: R600a Refrigerant Warning • This appliance contains a small quantity of R600a refrigerant which is environmentally friendly, but flammable. It does not damage the ozone layer, nor does it increase the greenhouse effect. • During transportation and installation, ensure that the tubing of the refrigerant circuit is not damaged.
INSTALLATION INSTRUCTIONS Before Using the Freezer Remove the exterior and interior packing. Before connecting the freezer to a power source, let the unit stand upright for approximately 4 hours to mitigate the possibility of a malfunction in the cooling system from improper handling during transportation. Clean the interior surface with lukewarm water using a soft cloth.
Temperature Control The temperature control (thermostat knob, turned by coin or screw driver) is located near the top of the unit. Setting “1” is the warmest and setting “4” is the coldest. The setting “2” is for normal operating conditions. But it can be adjusted to the setting that best suits your needs. Defrosting The appliance isn’t frost free model and it need to manual defrost regularly.
GENERAL CARE AND MAINTENANCE Cleaning the Freezer Upon installation of your new appliance, it is recommended that it be cleaned thoroughly and properly maintained thereafter. Turn off the freezer and then unplug the unit from the wall outlet. Remove all food content before washing the inside with a damp cloth soaked in lukewarm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a litre of water.
TROUBLESHOOTING GUIDE Many common freezer problems can be easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling for service. PROBLEM Freezer does not operate. The light is not working. Compressor runs all the time POSSIBLE CAUSES Power cord isn’t plugged in properly. The circuit breaker tripped or a blown fuse. The light bulb may be damaged. Refer to page 6 on how to change the globe.
freezer continues to run. Bubbling or gurgling sound, like water boiling. Vibrations. Refrigerant (used to cool freezer) is circulating throughout the system. This is normal operation. Check the freezer is on a level/even surface. Floor is uneven or weak. Freezer rocks on the floor when it is moved slightly. Be sure floor can adequately support freezer. Level the freezer by putting wood or metal shims under part of the freezer. The freezer is touching the wall.