ENGLISH CSH431W CSH430B CSH429S USER MANUAL FROST FREE VERTICAL FREEZER Keep this manual in a safe location and use it for reference. Read this manual carefully before commencing operation of this appliance, and comply with the Terms and Conditions. www.chiq.com.
SAFETY WARNING! It is hazardous for anyone other than authorized service personnel to carry out servicing or repairs which involves the removal of covers. To avoid the risk of an electric shock do not attempt to repair this appliance yourself. WARNING! Risk of fire / flammable materials. Safety tips Do not use electrical appliances such as a hair dryer or heater to defrost your Freezer. Containers with flammable gases or liquids can leak at low temperatures.
Do not damage the refrigerant circuit. Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of type recommended by the manufacturer. Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
friendly are used for the refrigerator, causing no damage to the ozone layer and having a very small impact on the global warming. R600a is flammable, and sealed in a refrigeration system, without leakage during normal use. But, in case of refrigerant leakage due to the refrigerant circuit being damaged, be sure to keep the appliance away from open flames and open the windows for ventilation as quickly as possible.
Note：Figure 1, Figure 2 only illustrate the space demand of the product. 3. Level ground Place the refrigerator on the solid and flat ground (floor) to keep it stable, or else, it will give rise to vibration and noise. When the refrigerator is placed on such flooring materials as carpet, straw mat, polyvinyl chloride, the solid backing plates should be applied underneath the refrigerator, so as to prevent color change due to heat dissipation.
extinguished automatically if no key operation within 3 minutes. When the display is off, it will light up if any door is opened or any key is pressed. The following key operations are valid only when the keys are unlocked and gets illuminated on the display. (Refer to 1.6 for unlocking the keys) 1. Functions 1.1 Switchover between fridge/freezer mode Press and hold the Temp. key for 3s, then switchover between the fridge mode and the freezer mode can be realized. 1.2 Temp.
Precautions for use ⚫ The appliance might not operate consistently (there is possibility of defrosting or temperature becoming too warm in the frozen food compartment) when sited for an extended period of time below the cold limit of the temperature range for which the refrigerating appliance is designed ⚫ The information of climate type of the appliance is provided on the rating plate.
control knob to the low mode, with the freezer temperature lowered. So, foods can be frozen up in fast manner, with the food freshness well kept. Tips for special needs Moving the refrigerator/freezer •Location Do not place your refrigerator/freezer near a heat source, e.g. cooker, boiler or radiator. Avoid it from direct sunlight in out-buildings or sun lounges. •Leveling Make sure to level your refrigerator/freezer using the front leveling feet.
Flip cover: Keep the flip cover in the vertical direction, align its right side with the revolving shaft opening, and then pull out with force to disassemble the flip cover. Note: It is forbidden to close the door when the flip cover is opened, otherwise the refrigerator door may be damaged. Simple fault analysis and elimination With regard to the following small faults, not every failure needs to be fixed by the technical service personnel; you can try to solve the problem.
b) e) Lift the refrigerator door up by 50mm to remove the refrigerator door. f) Remove the front leveling feet, use the tool to remove the 4 screws to fix the hinge, and then remove the hinge. g) Take the lower left hinge out of the accessory bag, and install it on the refrigerator with the tools. Screw off the three bolts on the upper hinge, remove the upper hinge, and pry off the upper hinge cover, door sleeve, magnet.
h) i) Remove the door stopper and door closer from the door, take out the door closer from the accessory bag, and install it on the left side of the door. l) Remove the magnet from the door right side, and install it on the door left side m) Remove the handle cover, screw off the screws fixing the handle, and remove the handle.
o) After the door handle is installed, the door reversing operation is finished. For installation of the door handle, please refer to the above Item n. Certifications Electrical information This electrical appliance must be grounded This product is equipped with a plug, which is suitable for all houses equipped with sockets meeting the current specifications If the fitted plug is not suitable for your socket outlets, it should be cut off and carefully disposed of.
