User Manual

3
INSTALLATION INSTRUCTIONS
Before Using the Refrigerator
• Remove the exterior and interior packing.
• Before connecting the refrigerator to a power source, let the unit stand upright for
approximately 4 hours to mitigate the possibility of a malfunction in the cooling
system from improper handling during transportation.
• Clean the interior surface with warm water using a soft cloth.
Installing the Refrigerator
• This appliance is designed to be free standing only, and should not be recessed or
built-in.
• Allow at least 50mm of space on the back and 100mm on each side of the
refrigerator to allow proper air ventilation. Insufficient space will result in cooling
and working life issue and voiding warranty.
Dimensions in mm:
W
D
H
A
B
C(°)
E
F
912
704
1770
1524
1062
160
50
100
• Place the refrigerator on a leveled/even floor surface that is strong enough to
support the weight of the refrigerator when it is fully loaded to prevent vibrations.
• Place the refrigerator on a concrete, tile floor or waterproof floor is
recommended. The fridge will produce defrost water or condensation moisture,
it might cause water damage in some extreme circumstances.
• The front feet can be adjusted to level the appliance properly. Adjust the two
front feet to keep the refrigerator leveled or elevated.
• Situate the refrigerator away from direct sunlight and sources of direct heat (stove,
heater, radiator, etc.). Direct sunlight may also affect the acrylic coating and heat
sources may cause an increase power consumption.
• This unit is not designed for outside installation.
• Avoid situating the refrigerator in moist OR pest infestation areas.
• This refrigerator appliance requires a standard 220-240VAC 50/60Hz electrical outlet
with three-prong ground. Do not under any circumstances cut or remove the third