User's Manual

2. Installation
1) Put the batteries in transmitter. Make sure the positive and negative ends of the batteries
match the polarity markings inside the batteries compartment.
2) Plug receiver into computer USB port.
3) Wait until LED(ⓔ) of receiver flickers regularly.
4) If LED(ⓔ) of receiver flickers, it means that the product is correctly recognized.
5) Push left or right button of transmitter for more than 2 seconds. After stop flickering,
recognizing is completed.
6) Open powerpoint and push right or left button of transmitter. And then check [table1].
7) In case of failure in working [table1], separate receiver from USB port. And insert receiver into
USB port again. Repeat the process above.