User's Manual

Setting up the XPG200

XPG200 User Manual

3. Setting up the XPG200

1. Insert 2 x AAA batteries into XPG200 Transmitter.

2. Insert the Receiver into the USB port of the PC.

3. The Receiver will be installed automatically and

will work immediately after it is inserted into the

USB port.

4. Default start is presentation mode. The left

button( ) will start and stop the presentation.

The right button( ) will switch Task Bar

programs. To move forward, use the right mouse

button. To move backward, use the left mouse

button.

5. To use the mouse function, push the Mode

Selector located on the right side of the

Transmitter. The RED LED will blink. Control the

Optical Touch Sensor to move the mouse arrow.

Press the left( ) and right( ) buttons to

activate the mouse left click and mouse right click

functions.

6. If you see the failure in recognizing the Receiver,

please follow ID pairing process.

ID Pairing between Transmitter and Receiver

1. Press and release “LED & RESET button” on the Receiver for 1 second. The LED(Green) will start

blinking and blink for 10 seconds.

2. Press together Two buttons (Start or End Slide Show, Alt+Tab) on the Transmitter and release the

buttons when the LED turns off automatically.

3. If ID paired successfully, the LED on the Receiver and Transmitter will blink 4 times together.

4. XPG200 is ready to use.

- In case of the failure in ID pairing -

Remove and reinsert the USB Receiver. Please repeat above installation processes.