Specifications

Chongqing Lihua Automation Technology Co., Ltd Lihua_BLE_002 Hardware specification
WARNINGS
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Caution: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that
to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
Information for the OEM Integrators
This device is intended for OEM integrators only. Please see the full grant
of equipment document for restrictions.
Label Information to the End User by the OEM Integrators
If this certified module is installed inside the host device, then the
outside of the host must be labeled with “Contains FCC ID:
2AL6E-LHT202201K” and “Contains IC ID: 25913-LHT202201K”.