Specifications

Chongqing Lihua Automation Technology Co., Ltd Lihua_BLE_002 Hardware specification
The requirement for KDB 996369 D03:
1 List of applicable FCC rules
FCC Part 15. 247.
2 Summarize the specific operational use conditions
None
3 Limited module procedures
The module is a single module, so this requirement is not applicable to
the product.
4 Trace antenna designs
The module uses the permanent external antenna, so this requirement is
not applicable to the product.
5 RF exposure considerations
After evaluation, the SAR requirement is deemed to be satisfied without
test. Please check the report for detail information.
6 Antennas
PCB antenna, Antenna Gain:0dBi.
7 Label and compliance information
If this certified module is installed inside the host device, then the
outside of the host must be labeled with “Contains FCC ID:
2AL6E-LHT202201K”and “Contains IC ID: 25913-LHT202201K”.
8 Information on test modes and additional testing requirements
The host manufacturer can use the software of SmartRF Studio 7 to make
the Bluetooth transmit continuously.
9 Additional testing, Part 15 Subpart B disclaimer
The module only complies with the FCC Part 15.247. If the module is
installed in the host device, the host manufacturer is responsible for
the compliance to any other FCC rules that apply to the host not covered
by the modular transmitter grant of certification. For example, if the
host manufacturer markets their product as being Part 15 Subpart B
compliant (when it also contains unintentional-radiator digital
circuity), then the host manufacturer shall provide a notice stating that
the final