Owners Manual

Chord Electronics
DAVE | Manual
_
Before connecting DAVE to any
third-party equipment, consult
the manufacturer’s user guide to
confirm compatibility.
When connecting DAVE to any
equipment, make sure that all
devices are o, including DAVE.
Once connected, switch all
equipment on starting with
the source and ending with the
amplification.
Initially, operate DAVE on its
lowest volume setting, gently
increasing to a comfortable
listening level.
Never operate DAVE at excessive
volume levels; permanent hearing
damage and/or loss can occur.
DAVE does not have internal
batteries and, therefore, must
be permanently connected to a
source of power.
The included 10-amp IEC power
cable plugs into DAVE.
Do not disconnect DAVE from
the power cable without first
switching the unit o to avoid
any damage.
1.1 Introduction
1.2 Protection against
liquids & heat
1.3 Dismantling & radio frequency
interference
1.4 Connecting your equipment
Connecting your equipment 1.4
Never disconnect the
power cable during
operation. Only
disconnect when DAVE
is o. If the power cable
is disconnected during
operation, there is a risk
of damage to connected
equipment.
7 // 35