User Manual

Chord Electronics
2go | User manual
22
“mode: Hotspot password reset”
“mode: Bluetooth PIN reset”
“factory reset”
“firmware update”
5. After reaching the desired option, wait 5 seconds. Press the Configuration button
B
one last time
when instructed:
“mode: press to enter XXXX mode”
“mode: entering XXXX mode”
NOTE
Selecting one of the three reset options requires you to hold the Configuration button
B
for several seconds.
TIP
Selecting “mode: current mode” will prompt 2go to tell you the current connectivity mode.
13.3 Bluetooth connection
2go’s Bluetooth connection is always available, no matter which mode is selected.
1. Enable Bluetooth on your control device.
2. Select 2go from the list of available devices.
3. If asked, enter 0000 as the input code. The 2go status LED
E
flashes purple when the connection is
registered.
NOTE
Bluetooth is a user-friendly wireless connection method, but can result in some loss of
sound quality. We recommend using a Wi-Fi connection for optimal sound quality.
TIP
The ‘Bluetooth’ PIN can be changed in the GoFigure app.