User Manual

Chord Electronics
2yu | User manual
6
5 Connecting 2yu to 2go
To connect 2yu to 2go:
1. Before operating 2yu with 2go, the
devices must be docked. Failure
to correctly dock the devices may
cause damage. Using the locking pins
supplied with the 2go (pins are not
supplied with 2yu), screw the pin into
2yu’s screw-thread until thumb-tight
and repeat with the second pin.
2. Ensure the locking hex bolts on
either side of 2go are loose and not
obstructing the connector holes.
Carefully align 2go with 2yu and slide
the two devices together. This is best
done on a flat surface.
3. Locate 2go’s locking hex bolts and
with the Allen key supplied with
2go, gently tighten the bolts until
comfortably tight. Do not over-tighten.
NOTE
If docking is
unsuccessful, gently remove 2go from
2yu and loosen each locking pin by
half a turn (don’t worry if the pins
move) and reattempt the connection.
Once successfully docked, re-tighten
the hex bolts.