User Manual

16
Maintenance
adjusting the settings
Always remember to make any changes to settings with the volume set low or an instant burst of sound could damage
your loudspeaker.
cleaning
To clean finger marks and other blemishes from your amplifier spray clear glass cleaner onto a soft lint free cloth and
then use the cloth to gently clean your amplifier.
changing the batteries in the remote control
Simply push the button on the bottom of your remote control to release the battery cover. Replace with four new AAA
batteries as shown inside the battery compartment.
servicing
There are no user serviceable parts in your Chord amplifier, and it should only be serviced by Chord Electronics
Limited or their expressly approved Service Agents.
Frequently asked questions
why aren’t any of the remote control buttons working?
Press the HIFI button to set up the remote control for pre-amplifier functions.
I’ve connected all the wires up but I can’t hear any sound?
Ensure that you’ve selected the correct input (e.g. Line 1) and the correct output (e.g. Output 1 ).
why is there humming coming from the loudspeakers?
Check that you’ve earthed the unit. The interconnects need to be properly screened and placed away from mains cables.
Interference can be reduced by using balanced inputs and outputs instead of RCA phono types.
the sound coming from the loudspeakers is distorted
Check that the speakers are connected properly. It may be that the volume is turned up too loud for your speakers.