User Manual

Output Connections

You need to connect the outputs on the back of the CPA3000 to a power amplifier in order to drive your loudspeakers.

There is one pair of balanced XLR outputs or one pair of RCA phono outputs each of which will drive a 68 ohm load.

Choose either depending on the appropriate input connection on your power amplifier. Left channel connections are at

the top, right channel connections are at the bottom.

Note: For optimum performance it is recommended that the balanced outputs are used where possible.

If you wish to bi-amp then ask your interconnect manufacturer to provide you with a balanced or RCA cable splitter. This

will split the single output from the CPA3000 into two signals one for each amplifier.

O/P