Quick Start Guide

Chord Electronics
Étude | Quickstart Manual
The Pumphouse, Farleigh Lane, East Farleigh, Kent, ME16 9NB, United Kingdom
[e-mail]
chordelectronics.co.uk
Quickstart Manual
Now that you have successfully completed the setup of your Étude
you can immediately begin to experience its transformational quality
on your music collection. However, we advise that you register your
product with us. Registering helps us give you the best possible
support and protects your investment:
Product registration 7.0
chordelectronics.co.uk/register-product/
Powering up Étude 6.0
With all devices correctly connected, the system is ready for playback.
With normal playback ensure both toggle switches should remain in
the same ‘down’ position. Again, ensure any volume controls are set to
the minimum before switching on your source and pre-amplifier, and
then finally Étude. This sequence should always be followed to protect
connected devices. Commence playback before slowly increasing the
volume to a comfortable listening level.
Once all audio inputs and outputs are connected, connect the power
cable to Étude.
Connecting the power to Étude 5.0
Spade connectors/bare wire: unscrew Étude’s binding posts, rotating
counter-clockwise until there is sucient room to attach the spade
connector and then re-tighten. For bare wire, continue to unscrew until
the post is exposed. Insert the wire adjacent to the post and beneath
the connector and re-tighten (finger-tight) ensuring there are no stray
wires.
WARNING: ALWAYS OBSERVE THE CORRECT POLARITY WHEN
CONNECTING SPEAKER WIRE. NEVER MIX LEFT AND RIGHT
WIRING.
or