Quick Start Guide

Chord Electronics
TToby | Quickstart Manual
The Pumphouse, Farleigh Lane, East Farleigh, Kent, ME16 9NB, United Kingdom
[e-mail]
chordelectronics.co.uk
Quickstart Manual
Now that you have successfully completed the setup of your TToby
you can immediately begin to experience its transformational quality
on your digital music collection. However, when you spare a moment,
we advise that you register your product with us. Registering helps
us give you the best possible support and protects your investment:
Product registration 7.0
chordelectronics.co.uk/register-product/
Powering up TToby 6.0
With all devices correctly connected, the system is ready for playback.
Again, ensure any volume controls are set to the minimum before
switching on your source and preamplifier, and then finally TToby.
This sequence should always be followed to protect connected
devices. Commence playback before slowly increasing the volume to a
comfortable listening level.
Once all audio inputs and outputs are connected, connect the power
cable to TToby.
Connecting the power to TToby 5.0
Spade connectors/bare wire: unscrew TToby’s binding posts, rotating
counter-clockwise until there is sucient room to attach the spade
connector and then re-tighten. For bare wire, continue to unscrew until
the post is exposed. Insert the wire adjacent to the post and beneath
the connector and re-tighten (finger-tight) ensuring there are no stray
wires.
WARNING: ALWAYS OBSERVE THE CORRECT POLARITY WHEN
CONNECTING SPEAKER WIRE. NEVER MIX LEFT AND RIGHT
WIRING.
or