User Manual

Chord Electronics
TToby | Manual
_
Protection against
liquids & heat
1.2
The TToby is not
protected against liquids
of any kind. Never place
containers of liquid on TToby.
Never allow TToby to come
into contact with moisture or
liquids; doing so could result in
electrocution or damage to the
TToby’s internal circuitry.
Be aware that liquids, including
water that has dried, can leave
minerals that can aect the
PCB and other components,
which could eventually lead to
oxidisation and short-circuiting.
If the TToby comes into contact
with moisture or liquids,
immediately disconnect from
the mains power supply, and
connected equipment, and
contact Chord Electronics for
further advice.
The TToby has internal
thermal protection which
will increase the speed
of the cooling fans if excessive
temperatures are being reached.
Should this occur then check that
TToby has adequate ventilation
and/or reduce the volume level
until TToby has cooled and the
fans slowed.
Never operate the TToby near
sources of heat or naked flames
as this will decrease the lifespan
of the internal components. It is
advised that you do not operate
the TToby in an area of direct
sunlight or on top of significant
heat- producing devices.
Please be aware that it is entirely
normal for the TToby to become
warm during use, particularly
within a stacked configuration.
If you are concerned about the
temperatures, please switch
the device o and consider a
dierent placement.
1.1 Introduction
1.2 Protection against
liquids & heat
1.3 Dismantling & radio frequency
interference
1.4 Connecting your equipment
5 // 23