User Manual

Chord Electronics
TToby | Manual
_
Before connecting the TToby
to any equipment, consult the
manufacturer’s user guide to
confirm compatibility.
When connecting the TToby to
any equipment please make sure
that all devices are o, including
the TToby.
Once connected, switch all
equipment on starting with
the source and ending with the
amplification.
Initially, operate the any
connected equipment on its
lowest gain setting and lowest
volume setting, gently increasing
to a comfortable listening level.
Never operate connected
equipment to the TToby
at excessive sound levels;
permanent hearing damage and
loss can occur.
The included 10A Mains IEC cable
lead plugs into the TToby.
If the power supply is
prematurely disconnected TToby
may still remain active for up to
15 seconds, however, this may
cause damage to connected
equipment.
1.1 Introduction
1.2 Protection against
liquids & heat
1.3 Dismantling & radio frequency
interference
1.4 Connecting your equipment
Connecting your equipment 1.4
WARNING: Never
disconnect the
power cable during
operation. Only disconnect
when TToby is o. If the
power cable is disconnected
during operation there is a
risk of damage to connected
equipment.
7 // 23