User Manual

Chord Electronics
ULTIMA PRE 2 | Manual
_
The remote control gives you
control over your full set up. The
top section is reserved for Blu
MKII and Dave while the bottom
section is used for ULTIMA PRE 2.
Your selection on the remote
will show on the ULTIMA PRE 2
display screen. As the infra-red
remote control requires a direct
line of sight to the viewing portal,
please avoid placing objects in
front of either device.
NOTE: The volume buttons will only work
with ULTIMA PRE 2. To change inputs
when DAVE is also in the system use the
side buttons to change settings. Please see
DAVE manual on using the remote control.
3.1 Getting to know Prima
3.2 The front panel
3.3 The top panel
3.4 The rear panel
3.5 The remote control
1
23
456
789
0
SHUF TIME
LEVEL SETUPBYPASS
OP1+2
MUTE
OP1OP2
BAL- BAL+
ESC
HIF
IA
V
OK
LINE1 LINE4TP-01 TP-04
LINE2 LINE5TP-02 TP-05
LINE3MAINTP-03 TA PE
ZONE DIM LOCK
REP
DISC1 RAD DISC RAD
DISC2TAPE2 DISC2TAPE1
VIDBUS AVID BUS B
VOL-
VOL+
LINE+LINE-
TONE
The remote control 3.5
16 // 33
Standby
Input contol for BUS A
and B
NOTE: Please only
insert AAA batteries
into the IR remote
control and observe the
correct orientation as
indicated within the remote
control. Failure to do so
could result in non-operation
or battery leakage.
Mute
ULTIMA PRE 2 Volume
control +
ULTIMA PRE 2 Volume
control -