User Manual

Chord Electronics
ULTIMA PRE 2 | Manual
_
In order to connect up ULTIMA
PRE 2 to a source, you must
connect your cables to one of the
inputs listed below. ULTIMA PRE
2 can have up to 8 inputs at once
so it gives you the flexability to
fully curate your system with
minial eort required.
First, you must ensure that
ULTIMA PRE 2, and any
connecting equipment, is turned
o.
For a balanced input use the
double XLR inputs listed below.
For unbalanced inputs use the
other 4 inputs listed below.
4.1 Placement
4.2 Connecting an input to
ULTIMA PRE 2
4.3 Connecting ULTIMA PRE 2 to a
power amplifier
4.4 Connecting ULTIMA PRE 2
to a recording device
4.5 Connecting ULTIMA PRE 2
to a AV device
4.6 Connecting ULTIMA PRE 2
to headphones
Connecting an input to
ULTIMA PRE 2
4.2
19 // 33
Balanced
input 1-4
Unbalanced
line 5-8
Please note that each input is
arranged as a stereo pair, right
and then left. Later, when you
come to switch ULTIMA PRE 2
on, each pair of inputs will be
shown as ‘LINE X’ on the display.
LINE 1 begins the row of XLRs
and LINE 5 begins the row of
RCA.
It should be carefully noted
that the pair of XLR, RCA, A/V
and the right most T1 and T2
connectors next to the IEC
input are outputs. You must not
connect any inputs here.