User Manual

Chord Electronics
ULTIMA PRE 2 | Manual
_
In order to use the ULTIME PRE
2 you can either use the buttons
on the front of the unit or the
remote control to navigate the
menu.
V.U: The V.U button can be used
when you‘d like to change the
view of the Volume Unit on the
display screen.
Button A: The A button can
be used to select Bus A. Press
several times to select your
desired input. ULTIMA PRE 2
will remember this setting. Your
Ultima Pre 2 should be set to
Bus A for normal operation. The
selected input will automatically
be sent to the recording T1
phono outputs. View section 5.3
for further details.
5.1 Basic navigation
5.2 Volume and balance control
5.3 Display
5.4 Recording
5.5 Av bypass
Basic navigation 5.1
25 // 33
Alternatively you can use the
lower buttons on the ULTIMA
PRE 2 remote to select the
correct input and output. The left
hand side is for Bus A and right
hand side is for Bus B.
Button B: The B button can be
used to select Bus B. Press the B
button several times to choose
your input. This will be displayed
with dots under the input to
indicate it is Bus B. The selected
input will automatically be
sent to the recording T2 phono
outputs. View section 5.3 for
further details.
Set button: The set button will
allow you to select an output.
Press the button several times
to select the right ouput. View
section 5.3 for further details.
LINE1 LINE4 TP-01 TP-04
LINE2 LINE5 TP-02 TP-05
LINE3 MAIN TP-03 TAPE
DISC1 RAD DISC RAD
DISC2 TAPE2 DISC2 TAPE1
VID BUS A VID BUS B
BUS A BUS B