User Manual

Chord Electronics
ULTIMA PRE 2 | Manual
_
Bus A selection: To assign the
main output with a particular
input signal, press the A button
several times to cycle through
the 7 line inputs until, the display
shows the input you wish to use.
The options are shown in the
diagram below;
5.1 Basic navigation
5.2 Volume and balance control
5.3 Display
5.4 Recording
5.5 Av bypass
Display 5.3
27 // 33
Output selection: To select
the output press the set button
several times to cycle through
the 4 outputs listed. Please note
that both XLR and RCA outputs
will be live at the same time and
will both be listed as Out-1. The
options are shown in the diagram
below;
Bus B selection: To assign an
additional output to Bus B with a
particular input signal, press the
B button several times to cycle
through the 7 line inputs until, the
display shows the input you wish
to use. Note that the inputs will
display with lines underneath to
indicate it is Bus B. The options
are shown in the diagram below;