User Manual

Chord Electronics
ULTIMA PRE 2 | Manual
_
Protection against
liquids & heat
1.2
ULTIMA PRE 2 is not
protected against liquids
of any kind. Never place
containers of liquid on ULTIMA
PRE 2. Never allow ULTIMA PRE
2 to come into contact with
moisture or liquids; doing so
could result in electrocution or
damage to the ULTIMA PRE 2’s
internal circuitry.
Be aware that liquids, including
water that has dried, can leave
minerals that can aect the
PCB and other components,
which could eventually lead to
oxidisation and short-circuiting.
If the ULTIMA PRE 2 comes
into contact with moisture or
liquids, immediately disconnect
from the mains power supply,
and connected equipment and
contact Chord Electronics for
further advice.
The ULTIMA PRE 2
has internal thermal
protection which will
shut down the unit in the event
of excessive temperatures being
reached. Never operate the
ULTIMA PRE 2 near sources of
heat or naked flames as this
will decrease the lifespan of the
internal components. It is advised
that you do not operate the
ULTIMA PRE 2 in an area of direct
sunlight or on top of significant
heat- producing devices.
Please be aware that it is
entirely normal for the ULTIMA
PRE 2 to become warm
during use, particularly within
a stacked configuration. If
you are concerned about the
temperatures, please switch the
device o or consider a dierent
placement.
1.1 Introduction
1.2 Protection against
liquids & heat
1.3 Dismantling & radio frequency
interference
1.4 Connecting your equipment
5 // 33