User Manual

Chord Electronics
ULTIMA 5 | Manual
_
Before connecting the ULTIMA
5 to any equipment, consult the
manufacturer’s user guide to
confirm compatibility.
When connecting the ULTIMA 5
to any equipment, make sure that
all devices are o, including the
ULTIMA 5.
Once connected, switch all
equipment on starting with
the source and ending with the
amplification.
Initially, operate the any
connected equipment on its
lowest gain setting and lowest
volume setting, gently increasing
to a comfortable listening level.
Never operate connected
equipment to the ULTIMA
5 at excessive sound levels;
permanent hearing damage and
loss can occur.
The included 15 amp IEC mains
lead plugs into the ULTIMA 5.
If the power supply is
prematurely disconnected
ULTIMA 5 may still remain active
for up to 15 seconds, however,
this may cause damage to
connected equipment.
1.1 Introduction
1.2 Protection against
liquids & heat
1.3 Dismantling & radio frequency
interference
1.4 Connecting your equipment
Connecting your equipment 1.4
WARNING: Never
disconnect the
power cable during
operation. Only disconnect
when ULTIMA 5 is o. If the
power cable is disconnected
during operation there is a
risk of damage to connected
equipment.
7 // 24