D40 USER MANUAL HOME AUDIO • CAMBRIDGE
CONTENTS EN Contents ������������������������������������������������������������������������������������������������������������������������ 2 Box Contents ����������������������������������������������������������������������������������������������������������������� 3 Controls & Functions ����������������������������������������������������������������������������������������������������� 4 Setting up your Majority D40 Speakers �������������������������������������������������������������������������
BOX CONTENTS EN WHAT’S IN THE BOX A. Majority D40 Bookshelf Speakers D. Instructions Guide B. 3.5mm to 3.5mm AUX Cable E. Remote Control C. 3.5mm to RCA Cable F.
EN CONTROLS & FUNCTIONS FRONT VIEW 1 2 1. Remote Sensor 2. SIDE VIEW Speakers 7 3 4 5 6 3. Mode 6. Headphone Jack 4. Vol + / Next 7. Mode indicator lights 5.
CONTROLS & FUNCTIONS EN BACK VIEW 15 14 9 8 13 10 12 11 8. Speaker connector cable 12. 100--240V/50-60HZ Power 9. Speaker input 13. USB slot 10. OPTICAL input 14. SD Card slot 11. Power On/Off 15.
CONTROLS & FUNCTIONS EN REMOTE CONTROL 16 17 19 28 18 20 27 21 22 23 24 6 26 25 16. Power 17. Reset 18. Vol + 19. Play/Pause 20. Previous/Back 21. Vol - 22. Treble - 23. Bass - 24. Mode 25. Bass + 26. Treble + 27. Next 28.
SETTING UP YOUR MAJORITY D40 SPEAKERS EN Please note that the instructions in this manual will refer to the speaker or remote control button number e.g (Ref.*number*) in accordance with the diagrams on pages 2-4. Connecting and powering the unit Using the power cord provided, plug one end into the back of the primary speaker (Ref.12) and plug the other end into a mains socket. Switch the unit on at the back of the primary speaker (Ref.11).
EN BASIC OPERATION Basic controls Volume, treble and bass can be changed on all speaker modes. Use the 🔈+ (Ref.18)/(Ref.4) and 🔈- (Ref.21)/(Ref.5) buttons to control the volume. Press 🔈X (Ref.28) to mute the audio. Use the Treble- (Ref.22), Treble+ (Ref.26), Bass- (Ref.23) and Bass+ (Ref.25) to control the bass and treble settings of the sound. Press ‘RESET’ (Ref.17) to reset the treble and bass settings. In Bluetooth, SD, or USB mode, use the ⏴ ⏵ (Ref.20)/(Ref.
BLUETOOTH, SD & USB CONTROLS EN Please note that the following controls and functions relate to Bluetooth, SD card and USB mode only. For AUX and Optical controls and functions, please see the section ‘AUX and Optical Modes’ (page 8). Note: in the table below, (H) = ‘Press and hold’.
AUX AND OPTICAL MODES EN Use the 3.5mm to 3.5mm AUX cable or 3.5mm to RCA cable to connect an external AUX device to the ‘AUX’ input of the D40 speakers (Ref.15). Switch to AUX mode When an AUX cable is plugged in to the AUX port at the rear of the speaker (Ref.15), the unit will automatically switch to AUX mode (indicated with a red light (Ref.7)) and make 3 short ascending beeps. If necessary, select ‘AUX’ mode using the ‘Mode’ button (Ref.24)/(Ref.3).
BLUETOOTH MODE EN To connect an external device to the D40 speakers, ensure that the speakers are in ‘Bluetooth’ mode. Select ‘Bluetooth’ mode manually by using the ‘Mode’ button (Ref.24)/(Ref.3) until the corresponding mode indicator light, labelled ‘AUX/BT’, (Ref.7) lights up blue. The speakers will make a series of short ascending beeps to indicate that Bluetooth mode is now active. Switch Bluetooth on for your external device. Select ‘D40’ from the list of devices.
EN USB & SD CARD MODE USB To use USB mode, insert a USB drive into the USB port at the back of the speaker (Ref.13). The speakers will sound with 2 short beeps to indicate that USB mode is active, and the ‘USB/OPT’ mode indicator light (Ref.7) will light up blue. If necessary, select ‘USB’ mode using the ‘Mode’ button (Ref.24)/(Ref.3). SD To use SD mode, insert a SD/TF card into the SD port at the back of the speaker (Ref.14).
CONNECTING HEADPHONES EN Connect wired headphones (not included) to the headphone port of the Majority D40 speakers (Ref.6) to listen to audio through headphones. Ensure the volume is turned down before you use the headphones. You will now hear audio output through the headphones. Please note that the Majority D40 is not compatible with Bluetooth headphones.
TROUBLESHOOTING EN Observation Potential Cause/Solution Check whether the power is switched on or off No power/function at the wall. Check that the power adaptor is properly connected to the power outlet. Check whether unit is set to MUTE. Check whether MODE is correctly selected. No sound Turn up the volume on the speakers or on your external device. Check that cables are properly installed. Function disturbance Switch off and unplug the unit. Leave it for 2 minutes and switch it on again.
SPEC & WARRANTY EN SPECIFICATION Power Supply 100-240V/50-60Hz Bluetooth Mode: 3.5mm AUX-in USB reader SD reader Power consumption 0.5W (standby mode) Dimensions 223 x 137 x 179 mm Weight 3.80 kg Speakers 2*4” full range + 2 * 1” tweeter Bluetooth Version 5.0 Bluetooth range up to 10 meters Compatible file types MP3, WMA, FLAC, MAV, APE Maximum compatible USB/SD storage 64GB WARRANTY All products come with a standard 12 month warranty. All items must be registered on www.majority.co.
EN SAFETY INFORMATION 1. Read these instructions. ADDITIONAL WARNINGS 2. Keep these instructions. Instructions are also availa- The apparatus shall not be exposed to dripping or splash- ble for download at www.majority.co.uk ing and no objects filled with liquid, such as vases, shall 3. Heed all Warnings be places on the apparatus. 4. Follow all instructions Main plug is used to disconnect device and it should 5.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
HOME AUDIO • CAMBRIDGE WWW.MAJORITY.CO.
