Product Manual

Using a stud nder attach bottom

section of True Plumb to a stud. If

base molding is over 1/4” thick the

bottom part of the True Plumb must

be mounted above base molding.

Note: When mounting to a concrete

wall use a 1/4” masonry bit and

expanders provided.

Use a level and mount the bottom

section with two screws provided.

- Next (this will probably take two

people) Screw in the white plastic

bolt “adapter “ into the bottom of the

U-joint. Hang plumb bob and gammon

reel from adaptor to help line top part

of the True Plumb with the bottom part

of True Plumb. Attach the top section

of the True Plumb to the wall so there

is at least 5 feet 2 inches between the

bottom of the U-joint and top of bot-

tom adjusting plate of the bottom sec-

tion. Level and mount with two screws

provided. Note: if you think you might

use it for GPS x height 2 meter rod

the distanst is 7 ft. between U-joint

and bottom plate.

TRUE PLUMB

Instructions for

16TPL1000

16TPL1000 xed height True Plumb

This instruction sheet is for the 16TPL1000 True Plumb for use with regular telescoping prism poles.

Note: This True Plumb can be adapted to except GPS xed height 2 meter rods by ordering

Part # 16TPLADAPTER mini rod adapter.

Note: Do not mount next to a light switch or electric outlets.

P.O. Box 516

Ross, OH 45061

Part # 16TPLADAPTER

Mini Rod Adapter for

the GPS xed height 2

meter rods.

PAGE 1
TRUE PLUMB Instructions for 16TPL1000 16TPL1000 fixed height True Plumb This instruction sheet is for the 16TPL1000 True Plumb for use with regular telescoping prism poles. Note: This True Plumb can be adapted to except GPS fixed height 2 meter rods by ordering Part # 16TPLADAPTER mini rod adapter. Note: Do not mount next to a light switch or electric outlets. 1- Using a stud finder attach bottom section of True Plumb to a stud.
PAGE 2
TRUE PLUMB Calibration: 1. 1. Screw in white plastic bolt “Adapter” into bottom of U-joint. 2. Place the spare plumb bob tip provided upside down in bottom adjust plate. 3. Using a Plumb bob and 6-12 ft. Gammon Reel, hook the plumb bob line through eyelet on the adaptor. Lower the plumb bob down until it almost touches the upside down plumb bob point. 4. Loosen nut on the bottom adjusting plate using a 1/2” wrench and move the plate so both plumb bob tips line up with each other.