Technical data

warm-up phase. As a result, the pressure inside the chamber is
not affected.
Fig. 31 The programmer module shifts the warm-up phase into the freezing
phase so that it takes place prior to the first drying section
The programmer module data “set values”, “actual values” and
“status” are shown at the usual locations in the values window, in
the mimic diagram and in the status line.
Fig. 32 Pop-up window of the programmer module
The programmer module can be activated by selecting the
Program menu. This is only possible in case no program has
been loaded so far. A pop-up menu opens and can be used to
select the desired function (load, modify, copy, delete or new
program).
56 • LSC Control System Operating Manual Freeze Dryer ALPHA 1-4 LSC / ALPHA 2-4 LSC