Operator`s manual

CHRISTIE DIGITAL SYSTEMS 4-1

August 7, 2003

4. INSTALLATION PROCEDURES

4.1. UNPACKING

Follow these instructions if the unit is crated.

Christie recommends that the unit be moved to the installation site before

uncrating.

1. Be sure container is upright.

2. Open crate and remove packing.

3. Carefully remove unit from crate.

4. Thoroughly inspect unpacked unit for damage that may have occurred during shipping.

Any damage discovered should be reported to the transportation company at

once for inspection and filing of claim.

4.2. INSTALLATION

Place console in intended operating location in projection booth.

4.2.1. LEVELING F EET

Install four (4) leveling feet by screwing one into each of the four corners underneath base

until about 1/2 inch of thread remains exposed. (See Item 8 in Figure 4-1.)

Christie recommends carefully tilting the console to one side to install the

first two feet, then tilting it to the other side to install the other two feet.

An assistant is required to do this safely.