Specifications

Cube Installation and Setup
Entero HB Rear-Access Cube Installation and Setup Manual 10
020-101007-04 Rev. 1 (12-2014)
Components and hardware
All major components required to assemble a complete display cube are packaged and shipped
separately to the installation site. This includes the display cube enclosure, projector, display
screen, and pedestal. Check the contents of your shipment against the list below to make sure that
you have all the necessary hardware. Hardware is listed by component and applies to all models
unless otherwise noted.
Cube enclosures
• M6 75 mm hex screws (Qty. 10)
• M6 18 mm flat washers (Qty. 20)
• M6 lock washers (Qty. 10)
• M6 hex nuts (Qty. 10)
• M6 60 mm hex screws (Qty. 2)
• M6 24 mm flat washers (Qty. 4)
•Cable covers
• Long-screen bolts (Qty. 4)
• Short-screen bolts (Qty. 2)
•Panel plug
Screens
• M6 screws (Qty. 8)
• M8 set screws (Qty. 4)
The long and short–screen bolts required to secure a screen to the cube are shipped with the cube.
Pedestals
• M6 75 mm hex screws (Qty. 4)
• M6 flat washers (Qty. 8)
• M6 lock washers (Qty. 4)
• M6 hex nuts (Qty. 4)
•Cable covers (Qty. 4)
• Anchor bolts (Qty. 4)
Projector
• M6 cap screws (Qty. 8)
• M6 flat washers (Qty. 8)