Specifications

Cube Installation and Setup
Entero HB Rear-Access Cube Installation and Setup Manual 12
020-101007-04 Rev. 1 (12-2014)
designed pedestals can be used; however, the designer and installer must make sure the custom
structure meets performance and safety requirements.
1. Lift the cardboard packaging off of the cube enclosures and pedestals. Do not cut the packaging
with a knife.
2. Remove the back panels and set aside in a location where the panels will not be damaged.
The panels are secured with two sprint release clips each. Press down on the clips and tilt the
top of the panel out, and lift the panel away.
Notice. Failure to comply with the following may result in property damage.
• To ensure there is enough space for the cube enclosures, the pedestals must be installed a
minimum of four inches from the wall.
A
To secure pedestals to each other, connect at the four points on each side panel.
B
To secure display cubes to the pedestal, connect at the two points at the back and the two points at the front.
C
To secure display cubes, connect at the two points on the support bracket. (PE70/PE70HD pedestals only)
D
Front Panel (faces the room)
E
Adjustable feet (Qty. 4)
B
C
D
E
A
A
A
A
B
B
B
C