Specifications

Cube Installation and Setup
Entero HB Rear-Access Cube Installation and Setup Manual 13
020-101007-04 Rev. 1 (12-2014)
Construct a multiple pedestal platform
Before starting, check that you have all the required hardware. See Components and hardware on
page 10.
1. Slide
two pedestals
together and align
the front and rear
edges. (A)
2. To make sure that
the feet are flat to
the floor apply
downward pressure
on the pedestal.
3. Match the height of
adjacent pedestals.
To raise or lower the
pedestal, turn the
bottom nut on each
pedestal foot. (B)
4. Use a level to verify
that the pedestal is
level on all sides and
with the other
pedestal. (B)
Caution! Failure to comply with the following could result in minor or moderate injury.
• Make sure that the appropriately rated lifting equipment and a minimum of two people are
available for installation.
• Mount the pedestals on a permanent, hard surface such as a concrete floor. Elevated surfaces, such
as wood platforms are not recommended.
i
• Always start at the center and work outward. Make sure each pedestal is level.
• Do not fully tighten the hardware that attaches pedestals together until you have completed all of
your adjustments and installed all of the pedestals.
A B
C
D