Specifications

Cube Installation and Setup
Entero HB Rear-Access Cube Installation and Setup Manual 14
020-101007-04 Rev. 1 (12-2014)
5. To lock the pedestal foot in position tighten the middle
nut against the top nut.
6. Check that you can see threads inside the pedestal, at
the corner bracket where the foot is installed as
illustrated.
If threads are not visible, you have over-extended the
pedestal foot. Readjust the foot before continuing with
the installation.
7. Hand-tighten the
two pedestals together using four M6
x 75 mm hex screws, eight flat washers, four lock
washers, and four M6 hex nuts. Make sure that the
vertical seam between adjacent pedestals is as
narrow as possible and uniform from top to bottom.
(C)
8. Slide the next pedestal into position and repeat steps 2 to 7. (D)
9. Confirm that the platform is level and that all of the rear edges of the pedestals are aligned.
10. To secure the pedestals, torque the loose hardware to 98 ft-lb.
11. Use a level to confirm that the platform structure is level from end-to-end.
Secure the pedestal with anchor bolts
All display walls must be supported externally anytime the display wall is two rows or higher.
External support prevents the wall from tipping and causing personal injury or damage to the
display cubes.
Christie requires that the display wall is secured with either anchor bolts or tie backs. See Secure
the cubes with tie backs on page 19.
Notice. Failure to comply with the following may result in property damage.
• The pedestals must be perfectly level, or there may be difficulties when installing the cubes and
screens.
Caution! Failure to comply with the following could result in minor or moderate injury.
• External support for a display wall must be designed and implemented by a qualified installer and
must comply with local area safety standards. All display walls must have permanent external
supports.