Specifications

Cube Installation and Setup

Entero HB Rear-Access Cube Installation and Setup Manual 16

020-101007-04 Rev. 1 (12-2014)

Install display cube enclosures

Before starting, check that you have all the required hardware. See Components and hardware on

page 10

. With a crew of two or more people, complete each row of cube enclosures before starting

the next. Proper alignment reduces issues with image geometry and makes sure that the wall has a

seamless appearance. Once the wall is installed, it is difficult and time–consuming to fix an

alignment problem near the bottom of a wall.

Warning! Failure to comply with the following could result in death or serious injury.

• Tip Load! The maximum stacking limitation is five cubes high in a minimum two column display

wall. The display wall must be properly anchored anytime the wall is two rows or higher to prevent

tipping and provide stability. Use all the hardware provided to fasten the display cubes to the

support structure. See Secure the pedestal with anchor bolts on page 14 and Secure the cubes

with tie backs on page 19.

• When stacking display cubes, they must be installed on a level surface. If the surface is not level,

the stacked cubes could tip over and cause damage to the cubes or personal injury

• Appropriate lift equipment must be used to lift display cubes onto rows two or higher.

Notice. Failure to comply with the following may result in property damage.

• Do not cut the protective film off the mirror with a knife.

• Do not touch the optical mirror with your bare hands. Fingerprints left on the surface can impact

image quality.

• Do not bump or scratch the mirror during unpacking.

• A clearance of 3 ft or more is recommended behind the display cubes for serviceability and

installation.

Cable covers

3 rear access panels

Rear access panel spring release clip

Panel plugs

CC50

All other

models