Specifications

Cube Installation and Setup
Entero HB Rear-Access Cube Installation and Setup Manual 19
020-101007-04 Rev. 1 (12-2014)
Secure the cubes with tie backs
All display walls must be supported externally anytime the display wall is two rows or higher.
External support prevents the wall from tipping and causing personal injury or damage to the
display cubes.
Christie requires that the display wall is secured with either anchor bolts or tie backs. See Secure
the pedestal with anchor bolts on page 14.
Every column of cubes requires one tie back. Each tie back must be capable of withstanding a
pullout force of 500 lbs.
Determine the optimal gap between screens
As temperature and humidity vary, the acrylic screens acclimatize and can slightly expand or
contract. The screen gap is a buffer designed to allow for the summation of both thermal and
hygroscopic expansion rates.
1. Determine the level of control the environment has for both temperature and humidity
fluctuations.
2. Add the recommended screen gap size from the thermal increase table and the hygroscopic
increase table below.
3. Assemble the display wall with the resulting gap sizes.
Caution! Failure to comply with the following could result in minor or moderate injury.
• External support for a display wall must be designed and implemented by a qualified installer and
must comply to local area safety standards. All display walls must have permanent external
supports. Failure to comply could result in minor or moderate injury.
Warning! Failure to comply with the following could result in death or serious injury.
• The amount of external support required depends on the size of the display wall. Support
structures must be designed and implemented by a qualified installer and comply to local area
safety standards.