Specifications

Cube Installation and Setup

Entero HB Rear-Access Cube Installation and Setup Manual 21

020-101007-04 Rev. 1 (12-2014)

Install screens

1. Wearing the lint–free cotton gloves provided in the User Kit, remove the screen from the

packaging. Stand the screen vertically with the outside of it against a clean wall, or on a clean

flat surface with the outside of the screen facing down.

2. Remove the protective film from the screen.

3. Install the M6 depth adjustment screws and the M8 vertical alignment screws into the

designated positions on the screen. Make sure the screws are flush with the frame.

4. Working with a partner, lift the screen into position at the front of the display cube. Align the

screen with the cube face.

5. With 1 person supporting the screen from the front, secure the screen to the display cube using

4 long–screen bolts. Hand-tighten the mounting hardware. Leave enough play to allow for

alignment adjustments. Install the long screen–holding bolts from the rear of the display cube

and run them through the body of the cube.

Notice. Failure to comply with the following may result in property damage.

• Store the screen in a low traffic area away from the installation to protect it from accidental tipping

or scratching.

• Let the screen stabilize to ambient site conditions for a minimum of 24 hours prior to installation on

the cube.

• Read this entire section before installing the screens.

• Wear the lint–free gloves provided in the user kit (P/N: 139-100102-xx) when handling the screens

to prevent leaving fingerprints on the surface.

• Begin assembling the display wall with the center cube of the bottom row and work outwards to the

two sides.

• Start each row of the display wall with the center cube of the row, and work outwards.

• Check that you have all the required hardware. See Components and hardware on page 10.

Insert M6 Depth Adjustment Screw

Insert M8 Vertical Alignment Screw