Specifications

Cube Installation and Setup
Entero HB Rear-Access Cube Installation and Setup Manual 22
020-101007-04 Rev. 1 (12-2014)
6. For screens on the top row, use 2 long screen–holding bolts to secure the bottom of the screen
and 2 short M6 x 60 mm screws to secure the top. Each M6 x 60 mm screw should have 2 M6 x
24 mm washers on it.
7. Check and correct alignment and screen gap issues before adding another screen.
a. For depth adjustment: Insert 4 M6 screws at each corner of the screen, from the inside
of the frame so that the screw surfaces are flush. Turn the screw clockwise to push the
corresponding corner out from the cube body.
b. For vertical adjustment: Insert 2 M8 vertical alignment screws at each end of the
screen, from the inside of the frame so that they are flush with the inside surface of the
screen frame. Turn a screw clockwise to increase the height on that side of the screen.
Use vertical adjustments to equalize the seams between the cubes.
8. For the bottom row only, adjust the screen height so that the screen touches the pedestals to
prevent the screen from shifting.
9. Repeat steps 1 to 4 to install additional screens in the row. Leave a 0.5 mm (0.019”) gap
between each screen. Work from the center outwards.
10. Check and correct alignment and screen gap issues before adding a row of screens.
Misalignment is difficult to correct once all screens are in place.
i
• Always complete installing screens on the first row before starting onto the next row.
i
• These adjustments require 2 people. One person to make the adjustments on the inside of the
frame and the other person to check the adjustments on the outside of the frame.
0.5 mm
From inside screen,
or
screen adjustment
screws to adjust
screen gap
raise lower
Side View
Screen adjustment screws
short-screen bolts
(for top row only)