Specifications

Projector Installation and Setup
Entero HB Rear-Access Cube Installation and Setup Manual 25
020-101007-04 Rev. 1 (12-2014)
Unpack the projector
1. Remove the top foam from the box and place it on a stable surface.
2. Remove the projector from the box, invert it so the lens is facing up, and place it onto the top
foam.
3. Remove the foam piece wedged between the tray and the light module.
C
Optical Module (OM)
D
Electronic Module (EM)
E
6-axis Adjuster
F
Tray
G
Light Module (LM)
Caution! Failure to comply with the following could result in minor or moderate injury.
• The projector should be lifted by two people.
• Use the designated handles to help lift and support the projector.
• Use a stable cart to transport the projector.
Notice. Failure to comply with the following may result in property damage.
• Do not place the projector onto a surface with the line cord retainer side down. Failure to comply
may result in damage to the line cord retainer.
i
• The projector is shipped inverted upside down inside the packaging box.
• Christie recommends you keep the packaging in the event that a projector must be returned to the
factory for servicing.