Specifications

Projector Installation and Setup
Entero HB Rear-Access Cube Installation and Setup Manual 26
020-101007-04 Rev. 1 (12-2014)
4. Loosen the four screws securing the green knob, and turn the green adjustment knob on the 6-
axis adjuster CW or CCW to relieve the pressure on the foam piece.
Install projectors into cube enclosures
The projector must be lifted by two people. Use a stable cart to transport the projector. Refer to the
drawings given for your specific projector model for the mounting hole location and other technical
information and restrictions which may be useful during installation. There are several methods for
mounting the projector. In typical rear screen installations, the projector can be mounted to a
secure and level surface.
The Entero HB projector is shipped ready to install for rear access and folded optics in a Christie
display cube.
Required tools and hardware
• Eight M6 Cap screws
• Eight M6 flat washers
•M6 hex driver
1. Place the projector assembly on the mounting plate with the adjuster knobs at the back of the
display cube.
Notice. Failure to comply with the following may result in property damage.
• The projector vents provide ventilation, both for intake and exhaust. Do not block or cover these
openings. Do not install the projector near a radiator or heat register, or within an enclosure.
Failure to comply may result in equipment damage.
Adjustment Knob
Hex key
Loosen 4 screws