Specifications

Projector Installation and Setup
Entero HB Rear-Access Cube Installation and Setup Manual 28
020-101007-04 Rev. 1 (12-2014)
Connect AC
Each display is supplied with a power cord appropriate for your region.
1. Plug one end of the power cord into the AC receptacle on the power module.
2. Plug the other end of the power cord into a grounded AC outlet.
Connect the displays
Sources connect to the front input panel on the electronic module.
Caution! Failure to comply with the following could result in minor or moderate injury.
• Use only an AC supply within the specified voltage and power range. Do not attempt operation if
the AC power source is not within the rated voltage range, as specified on the license label, found
on the projector tray.
i
• Make sure the array is connected to a wall breaker with max. 20A.
• Can be connected to IT power distribution.
i
• The optional DVI-D interface supports a secondary or redundant input source. This feature is sold
separately.
• The two USB ports are not supported. For future release.
Optional DVI–D interface card
Source
DVI-D IN1
Output
DVI-D Loopout
Control
RS232
ETH1/USB1
Power
ETH2/USB2