Specifications

Projector Installation and Setup

Entero HB Rear-Access Cube Installation and Setup Manual 31

020-101007-04 Rev. 1 (12-2014)

Connecting displays with the DVI loop-through interface

Source connections are made to the input panel of the electronic module. Each input is clearly

labeled for easy identification.

• Use the DVI–I connector to connect digital video devices to the display.

• Use DVI cables to connect from each source to each display. Sources are typically from a

display wall processor with multiple output channels, one from each display.

If the installation requires one source to be displayed and scaled across multiple displays, connect

the source to the first display then use the DVI Out of that display to connect to the DVI-D Loopout

of the next display. Repeat for each display, and make sure that Tiling Mode is enabled.

The display wall can be configured to operate in independent mode or tile mode. In independent

mode the input video is not daisy–chained.

Independent mode

Tile mode—distribute one source across multiple displays

Turn the projector on

1. Toggle the main Power switch (located on the power module) to ON.

It takes approximately 1 minute for power to initialize.

• The optional DVI Loop-through interface supports a secondary or redundant input source. 

This feature is sold separately.

• Analog inputs are not supported.

• DVI Loop-through and Ethernet daisy chain configurations support a maximum of 25 displays.

Warning! Failure to comply with the following could result in death or serious injury.

• Do not attempt to turn the projector on if the AC supply is not within the specified voltage range.

Video Controller

DVI-D

Video Controller

DVI-D